等离子体助燃下超燃支板燃烧室燃烧特性数值研究

doi:10.13675/j.cnki. tjjs. 180676

推进技术 ›› 2019, Vol. 40 ›› Issue (9): 2075-2083.DOI: 10.13675/j.cnki. tjjs. 180676

等离子体助燃下超燃支板燃烧室燃烧特性数值研究

张喆¹,金星¹,席文雄¹

航天工程大学激光推进及其应用国家重点实验室，北京 101416

发布日期:2021-08-15
作者简介:张喆，博士生，研究领域为超声速燃烧及等离子体流动控制。E-mail：zhangzhezhe1993@163.com
基金资助:
国家自然科学基金 51606220国家自然科学基金（51606220）。

Numerical Study on Combustion Characteristics of Supersonic Strut Combustor under Plasma-Assisted Combustion

State Key Laboratory of Laser Propulsion & Application ,Space Engineering University, Beijing 101416, China

Published:2021-08-15

摘要/Abstract

摘要： 为了将支板喷注器与等离子体射流这两种促进超声速燃烧室燃烧的方式结合起来，设计了一种带有等离子体射流喷孔的支板燃烧室，并在超声速来流的条件下，针对燃料喷注总压、燃料喷注位置、等离子体射流介质、等离子体射流总压对燃烧室燃烧性能的影响进行了三维数值模拟。研究发现：增大燃料的喷注总压，燃烧室的燃烧范围明显增大，燃烧效率呈现出先增大后减小的趋势，在燃料喷注总压为2.0MPa时，燃烧效率达到最大值90.4%；不同的燃料喷注位置对燃烧室的燃烧范围影响较小；等离子体射流介质为O₂时，燃烧效率最高，燃烧范围最广；提高等离子体射流的喷注总压，能够提升凹腔剪切层高度，有效促进燃烧，但同时也带来了更高的总压损失。

关键词: 支板喷注器;等离子体射流;超声速燃烧;数值模拟;燃烧效率

Abstract: In order to combine the two methods of promoting the combustion in a scramjet combustor, the strut injector and the plasma jet, a strut combustor with a plasma jet nozzle was designed. Under the condition of supersonic flow, the three-dimensional numerical simulation of the effects of fuel injection total pressure, fuel injection position, plasma jet medium and plasma jet total pressure on the combustion performance of the combustor was carried out. The obtained results show that: increasing the total fuel injection pressure, the combustion range of the combustor increased significantly, and the combustion efficiency increased first and then decreased, when the total fuel injection pressure is 2.0MPa, the combustion efficiency reaches a maximum of 90.4%; different fuel injection positions had less influence on the combustion range of the combustor; when the plasma jet medium is O₂, the combustion efficiency is the highest and the combustion range is the widest. Increasing total injection pressure of the plasma jet can increase the height of the shear layer of the cavity and effectively promote combustion, but also bring higher total pressure loss.

Key words: Strut injector;Plasma jet;Supersonic combustion;Numerical simulation;Combustion efficiency

张喆,金星,席文雄. 等离子体助燃下超燃支板燃烧室燃烧特性数值研究[J]. 推进技术, 2019, 40(9): 2075-2083.

ZHANG Zhe¹,JIN Xing¹,XI Wen-xiong¹. Numerical Study on Combustion Characteristics of Supersonic Strut Combustor under Plasma-Assisted Combustion[J]. Journal of Propulsion Technology, 2019, 40(9): 2075-2083.

参考文献

[1] 丁猛, 余勇，梁剑寒，等. 碳氢燃料超燃冲压发动机点火技术试验[J]. 推进技术， 2004， 25(6): 566-569.
[2] Tetlow M， Doolan C. Comparison of Hydrogen and Hydrocarbon-Fueled Scramjet Engines for Orbital Insertion[J]. Journal of Spacecraft and Rockets， 2007， 44(2): 365-373.
[3] Sunami T， Murakami A， Kudo K， et al. Mixing and Combustion Control Strategies for Efficient Scramjet Operation in Wide Range of Flight Mach Numbers[R]. AIAA2002-5116.
[4] Sunami Tetsuji， Magre Philippe. Experimental Study of Strut Injections in a Supersonic Combustor Using OH-PLIF[R]. AIAA2005-3304.
[5] 洪延姬，席文雄，李兰，等. 等离子体辅助燃烧机制及其在高速气流中的燃烧应用研究评述[J]. 推进技术， 2018， 39(10): 1-15.
[6] Jacobsen L S， Carter C D， Baurle R A. Toward Plasma-Assisted Ignition in Scramjets[R]. AIAA2003-0871.
[7] Kiyotaka S， Ryoichi K， Takeshi T. Two-Stage Plasma Torch Ignition in Supersonic Airflows[R]. AIAA2001-3740.
[8] Macheret S O， Shneider M N， Miles R B. Energy Efficiency of Plasma-Assisted Combustion in Ram/Scramjet Engines[R]. AIAA2005-5371.
[9] Kimura I， Aoki H， Kato M. The Use of a Plasma Jet for Flame Stabilization and Promotion of Combustion in Supersonic Air Flows[J]. Combustion and Flame， 1981， (42): 297-305.
[10] Murakami K， Nishikawa A， Takita K. Ignition Characteristics of Hydrocarbon Fuels[R]. AIAA2003-6939.
[11] Minato R， Niioka T， Sugiyama H. Numerical Analysis of Supersonic Combustion by a Plasma Torch[R]. AIAA2005-3424.
[12] Takita K， Nakane H， Masuya G. Optimization of Double Plasma Jet Torches in a Scramjet Combustor[J]. Proceedings of the Combustion Institute， 2007， 31: 2513-2520.
[13] 韦宝禧，欧东，闫明磊，等. 超燃燃烧室等离子体点火和火焰稳定性能[J]. 北京航空航天大学学报， 2012， 38(12): 1572-1576.
[14] 段立伟，洪延姬. 等离子体火炬喷射频率对超声速燃烧特性的影响研究[J]. 推进技术术， 2015， 36(10): 1539-1546.
[15] 宋振兴，何立明，张建邦，等. 超音速等离子体点火过程的三维数值模拟[J]. 强激光与粒子束， 2012， 24(11): 2746-2750.
[16] 刘毅. 超声速燃烧室等离子体射流点火助燃特性研究[D]. 北京：装备学院， 2016.
[17] Kobayashi K， Mitani T， Niioka T. Asymptotic Analysis of Plasma Jet Igniter[C]. Saitama: Proceedings of the 21st International Symposium on Space Technology and Science， 1998.
[18] HUANG Wei， LI ShiBin， LIU Jun， et al. Investigation on High Angle of Attack Characteristics of Hypersonic Space Vehicle[J]. Science China Technological Sciences， 2012， 55(5): 1437-1442.
[19] Menter F. Zonal Two Equation k-w Turbulence Models for Aerodynamic Flows[R]. AIAA93-2906.
[20] Yu G， Li J G， Chang X Y， et al. Investigation of Kerosene Combustion Characteristics with Pilot Hydrogen in Model Supersonic Combustors[J]. Journal of Propulsion & Power， 2001， 17(6): 1263-1272.

等离子体助燃下超燃支板燃烧室燃烧特性数值研究

Numerical Study on Combustion Characteristics of Supersonic Strut Combustor under Plasma-Assisted Combustion

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价